ProDetailing R1 – Rims 250ml Ceramic Coating

119.00 Ex. Vat: 96.75

Nano-ceramic coating for rims. Dedicated for chrome, aluminum and paint-coated rims.

Super hydrophobic effect and protection from water, dust, salt and UV-rays.
Increased protection against scratches.
Extra hard ceramic self-cleaning rims’ protection.
It is also resistant to high temperatures created during braking.

The fastest way for permanent protection of every kind of rims: both painted and polished.
It gives a superb hydrophobic effect that lasts for months.

Description

Nano-ceramic coating for rims. Dedicated for chrome, aluminum and paint-coated rims.

Super hydrophobic effect and protection from water, dust, salt and UV-rays.
Increased protection against scratches.
Extra hard ceramic self-cleaning rims’ protection.
It is also resistant to high temperatures created during braking.

The fastest way for permanent protection of every kind of rims: both painted and polished.
It gives a superb hydrophobic effect that lasts for months.

How to apply the product:
1 Shake bottle well before use and wait 3 minutes before opening.
2 Wrap small cloth around soft-side of the applicator.
3 Apply few drops of R1 onto applicator covered with small cloth.
4 Apply thin and even layer onto rim.
5 Leave the layer on the surface for approx. 7-8 minutes (bonding time).
6 Buff the surface with microfiber towel to a high gloss.
7 Move to next paintwork section. Attention: Do not apply R1 to hot surfaces or in direct sunlight.

It is good to know that:
If you want to know if the product is ready to buff, first try to move a hanging towel over drying coating.
If the towel slides easily then wait a few minutes until the surface will start to slow it down.

For best results put up to 3 layers of the product with minimum time interval of 3 hours.

What you need to know:
1 Use thin rubber protective gloves.
2 Apply indoor only with temperature of 18-24 C.
3 Make sure the surface is clean and cool.
4 Degrease and remove old coatings from the glass before application.
5 Apply additional layers with minimum time interval of 3 hours.
6 Drying time after application of last layer – 8 hours.
7 Do not expose the car to water for 24 hours after coating.

Safety Data Sheet

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Go to Top